![]() ![]() D I S C L A I M E R My right to post information is protected under the rights for freedom act. 'Patience is a virtue, Possess it if you can' - How to Install Cams on ViX Image - / How to Setup Picons on ViX Image - How to Use Image Manager & Backup Manager on ViX Image - / How to Use Log Manager on ViX Image - How to Setup Inadyn on ViX Image - / How To Update Satellites.xml File - How To Stream TV To iPhone & iPad. Press OK and wait for box to come back on Once the box is on press Menu/Setup/Softcam / CI/Softcam Manager and in there if you have done everything correctly you should see CCcam 2.2.1 Press 'Green' to start CCcam 2.2.1 and it should now be active like below Finally Press 'Blue' to enable Auto Start and you are now ready and setup with CCcam 2.2.1 Hope you guys find this tutorial helpful any questions dont hesitate to ask in here. Hopefully this will serve as a good alternative for those that would like to load both C-line and F-line easily into Dreambox decoder for card sharing.Code: after CCcam 2.2.1 which is enigma2-plugin-cams-cccam.2.2.11.0-r0mipsel Once downloaded you need to transfer the enigma2-plugin-cams-cccam.2.2.11.0-r0mipsel.ipk file into the /tmp folder on the box like below Then transfer your CCcam.cfg file into the /etc/ folder now go to your box and press Menu Setup VIX or Blue Button Install Local Extension and you should have enigma2-plugin-cams-cccam.2.2.11.0-r0mipsel.ipk file in there Press 'Green' button to install and once completed it will ask for a 'Gui Restart'. Once completed, click on ‘Save CCcam.cfg to dream’ will make the change effective. Whenever there is any change required, remember to click on ‘Enable manual edit’ so that users can directly edit both the C-line and F-line on the screen. ![]() That is not all, it also allows users to configure the max hop and reshare level whenever users plan to reshare the card sharing with either EMU enabled/or disabled. On top of these, CCcam lines manager can do more like such as adding F-line and create C-line for your friend. After a successful connection is established, users can now add new c-line account just like what can be done by CCcam.cfg Editor. For the start, just key in the Dreambox IP (can be obtained from Communication Setup in Dreambox), username and password (default is ‘root’ and ‘dreambox’) followed by ‘Connection test’ press. Once download and run the executable file (no installation required), users will be brought to a simple interface. Named as CCcam lines manager, it has the same feature as CCcam but with additional ability to add F-line and create C-line in simple windows based User Interface. Previously we mentioned about the way to load CCcam file using FTP or using CCcam.cfg Editor and if you think that is too simpler for advanced users, here is another more complicated utility that users can try. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |